Because the structure of the back and neck of men's and women's clothing is different, it is impossible to use the same method when setting up, otherwise the collar will be loose in the dress.

Here are two ways to break the collar.

A woman's suit is broken.

The first step is to drop the original flip line 0.8 centimetres and lead the base point to 1 centimeters.

The second step is to draw an arc from the next 0.8 centimeters, to extract the loosening of the broken line, and then to remove the 0.8 cm outside the collar line, and to remove the 0.2 to 0.3 centimeters of the pattern in the middle.

In the third step, the leading animal is inclined 0.5 centimeters into the rear centerline of the collar, and the center line is vertical and the width of the collar is 0.8 centimeters wide.

The length of the male collar is larger than that of the female garment, and the dressing effect is different.

Men's shirt collar should be exposed about 2 centimeters, so the men's suit collar has a larger side dump. That is to say, the difference between the collar folding and the outer collar is large, so they have different ways to split the collar.

The first step is to set up the collar a=3 cm, the collar is b=3.5 cm, the lapel angle is 20 degrees, and also to divide the line shape 0.8 to 1 centimeters down the original barge line.

The second step, first in the back to the middle 1 centimeters, up 0.8 cm take place, and the collar point connection, for the vertical angle collar face plus 0.8 cm for 4.3 cm intersecting the middle line, take out the collar shape.

The third step is to break the broken line and the original bottom line as the radius and draw the arc as the lead foot line modeling.